Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFAAC Gate Motor & Opener in Summerlin: What to Know First
FAAC gate motor and opener work in Summerlin is what we do as an independent FAAC service provider, and most FAAC repairs are finished in a single visit once we’ve confirmed the model and the fault. Prices are quoted and agreed before a single bolt is turned, so the number you hear on the phone is the number on the bill. Call (866) 623-9848 and a live person answers, day or night.

This page is for the homeowner with a FAAC operator on the driveway – a 400, 390, 391, 770, or C720 – who wants it diagnosed correctly the first time, not guessed at. If your gate is creeping, stalling, or beeping at you, we’ve likely seen that exact symptom on that exact series somewhere in Summerlin.
How FAAC Products Fail – and How We Fix Them
FAAC builds a solid operator. What fails on a Summerlin driveway is usually the part the desert attacks hardest, or the installation detail nobody checked. These are the failures we see most:
- 400 and 390 series: the gate reverses for no reason. Nine times out of ten it’s the encoder or limit setting drifting, not the board. Summerlin’s heat swings pull the mechanics slightly out of tolerance over a season, and the operator reads that as an obstruction. We re-teach the limits and test the reversal force against the gate’s actual weight before we call it fixed.
- 391 and 770 slide operators: slow travel and grinding at the ends. On slide gates the culprit is usually a worn pinion or a track that’s picked up grit and grit-borne wear. FAAC pinions are a wear item; the trick is matching the replacement to the correct gear ratio so the operator doesn’t labor. We check the track, the pinion, and the motor draw together.
- Battery backup that quits after two summers. FAAC battery-backup enclosures sit in direct sun on many Summerlin walls, and heat is what kills lead-acid cells early. We test the cells under load rather than trusting the green light, and we talk honestly about where the enclosure should sit to get more life out of the next set.
- Board faults after a monsoon-season surge. Summerlin’s summer storms bring lightning and brownouts, and FAAC control boards are sensitive to both. When a board is gone we confirm it’s the board and not a shorted accessory (photocell, keypad, loop) before quoting a replacement – a bad $40 eye can mimic a dead board.
- Intercom and keypad integration that never quite worked. FAAC operators get paired with aftermarket access control all the time, and mismatched trigger voltage is the usual reason the gate ignores the keypad. We trace the trigger circuit and set the accessory to the operator, not the other way around.
That last point is one of the details owners can’t get from FAAC’s own documentation: on a FAAC board, the accessory power output is not always the same voltage the keypad wants, and wiring a 24V keypad straight to a 12V trigger is a common DIY-install mistake we correct regularly in Summerlin.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our FAAC Gate Motor & Opener Process
- 1
Call and describe it. A live person takes the call and gets the model, the symptom, and how the gate behaves. That call alone often tells us which parts to bring.
- 2
Diagnose on site. We test the operator, the gate’s mechanical freedom, the power, and every accessory on the circuit. A gate that binds will kill a healthy motor, so we separate motor fault from gate fault before quoting.
- 3
Parts decision. FAAC OEM parts where they matter (boards, encoders, gearboxes) and quality aftermarket where it’s the honest call (batteries, photocells, some pinions). We tell you which and why, and we never fit a part that voids a warranty you still have.
- 4
Repair or replace, in writing. You get the price before we start. If a repair is the square deal, we say so; if the operator is past saving, we say that too.
- 5
Test under real load. We cycle the gate, check reversal force, verify the battery backup, and walk the safety edges and photocells before we pack up.
- 6
Back it in writing. Every FAAC job is covered by our 90-Day Done Right Promise – if it’s not right, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterWhat FAAC Gate Motor & Opener Costs in Summerlin
Here’s the honest range for FAAC work in Summerlin. Final price depends on model, parts, and gate condition, and it’s always settled before work starts.
| Job | Typical range |
|---|---|
| FAAC diagnostic and tune-up | $89 – $150 |
| Limit/encoder re-teach, force adjustment | $150 – $280 |
| Battery backup replacement (cells) | $180 – $340 |
| Photocell / safety edge repair | $160 – $320 |
| Pinion or gear replacement (slide) | $250 – $450 |
| Control board replacement | $380 – $700 |
| New FAAC operator install (existing gate) | $1,200 – $2,600+ |
What moves the price: the model (a C720 board costs more than a 400), whether the gate itself needs mechanical work, and OEM versus aftermarket parts. Installation jobs are measured and scheduled – we give you a written price after we’ve seen the gate. Estimates are free. Call (866) 623-9848.
Why Summerlin Homeowners Call Ironworks Gate Co. Summerlin for FAAC Work
Because we do the job right and back it in writing. Our technicians are trained and equipped on nine gate-automation brands – FAAC, LiftMaster, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so if your FAAC shares a driveway with a LiftMaster or a Mighty Mule, or a neighbor’s gate runs Ghost Controls or DoorKing, we’re not guessing. We carry up to 13 years of hands-on experience across those lines, and our technicians are background-checked and uniformed, working in your home the way they’d work in their own mother’s. A live person answers the phone 24 hours a day, so a gate stuck open at 10 p.m. in Summerlin gets a real voice, not a voicemail tree. Every job is finished in a single visit whenever the parts allow, priced upfront, and covered by our 90-Day Done Right Promise. Standing offers include $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a permanent 5% senior and veteran discount.
FAQs
FAAC handles the manufacturer warranty, and Ironworks handles the diagnosis and, where covered, the repair as an independent FAAC service provider. We’ll tell you up front whether a fault looks warranty-eligible or normal wear, so you know before any work starts. Call (866) 623-9848 for a free estimate.
Most common FAAC parts – boards, encoders, pinions, batteries, photocells – are available to us with a short lead time, and many jobs are finished the same visit. Model matters: newer C720 and 770 parts sometimes need a day or two to source, and we tell you that on the call rather than after we’ve arrived.
Repair if the board, motor, or drive is sound and only a wear item or setting has failed; replace if the motor itself is failing, the gearbox is shot, or the model is old enough that parts get scarce. In Summerlin we weigh that honestly against what a repair actually buys you. Estimates are free.
Repairs and emergencies are often same-day or next-day in Summerlin, and a live person answers 24 hours a day. New FAAC installations are measured, ordered, and scheduled, so those get a written price and a date rather than a same-day promise.
Yes. On a FAAC installation we handle the low-voltage trigger wiring, the safety edges and photocells, and coordination on the power run so the operator is wired to FAAC’s spec. We test every safety device before we leave.
Call (866) 623-9848 for a free estimate. A live person answers day or night, the price is settled before work starts, and every FAAC job in Summerlin is covered by our 90-Day Done Right Promise.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin and nearby areas.