Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateLinear Gate Motor Replacement: The Summerlin Owner’s Guide
Replacing a failed Linear gate motor in Summerlin typically runs $950 to $1,850 installed for a residential swing or slide operator, and most jobs are completed in a single visit. If your gate has stopped reversing, moves in one direction only, or the motor hums but the arm doesn’t travel, you’re likely facing a motor or control board failure rather than a remote problem. Most Summerlin owners discover this on a Monday morning when the gate won’t open for the school run or the dog walker, and the arm just sits there. We stock the correct replacement or order it the same day, so you’re not waiting a week for a gate that won’t secure your driveway.

Which Linear Models This Applies To
Linear’s residential line covers a lot of ground, and the replacement motor you need depends entirely on which series is on your driveway. The most common models we see in Summerlin are the LDO (swing), the SWG and SWH (slide), and the older LA and LJ series that many 1990s-era estates still run. Before we quote anything, we read the model plate on the operator housing, or inside the control box if the plate has weathered off, and match the replacement to the exact model and gate weight. A 12-foot slide gate needs a different motor than a 20-foot one, and getting that wrong is the single most common reason a “replacement” fails in six months.
We source OEM Linear motors and control boards where they’re still in production, and quality aftermarket equivalents for discontinued series. We always tell you which one we’re quoting and why. Ironworks Gate Co. Summerlin is an independent service provider and is not affiliated with Linear, but we’re trained on the brand and know the model history well enough to spot a mismatch before it costs you.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Linear Gate Motor Replacement Is Failing
Linear operators are tough, but the Las Vegas Valley heat and the dust that comes with it push them hard. Our technicians have up to 13 years of experience reading these failures. Here’s what usually shows up before a motor finally quits:
- The motor hums but the gate doesn’t move. That’s usually a burned-out capacitor or a seized gearbox, not a dead motor. A $40 part often fixes it, and we’ll check before we quote a full replacement.
- The gate reverses or stops midway. On Linear swing operators this often points to a failing limit switch or a control board that’s lost its travel settings. In Summerlin’s summer heat, the board is usually the culprit.
- The gate moves in one direction only. A classic sign of a failed relay on the control board. It’s a fixable issue, and it’s worth checking before you assume the motor is gone.
- The operator runs hot or trips the breaker. Dust-clogged cooling vents and worn motor windings both cause this. If it’s the windings, replacement is the honest answer.
- You’re resetting the remote or the keypad every few weeks. That’s often a failing receiver or a low battery in the operator’s backup, not a remote problem. Worth a quick check before you buy a new remote.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Every Linear gate motor replacement we quote in Summerlin is priced upfront, in writing, and agreed before a single bolt is turned. Here’s what drives the range:
- Motor and operator unit: $550 to $1,100 depending on model and gate weight.
- Control board, receiver, or safety accessories: $80 to $220, quoted only if your existing units need replacing.
- Labor and commissioning: $220 to $480, including travel setup, force calibration, and a full test cycle.
- Disposal of the old operator: included in every quote.
Total installed typically lands between $950 and $1,850, and we tell you in the written estimate exactly what’s covered. Every job is backed by our 90-Day Done Right Promise. If something isn’t right, we come back and make it right, no arguing, no paperwork. We also offer $50 off any repair over $250, and a free second opinion on any written estimate you’ve already received.

DIY or Call Us?
Some things you can safely check yourself. Read the model plate, take a photo, note the gate weight, and test the remote batteries. If the operator hums but doesn’t move, don’t keep trying it. Spinning a seized gearbox or a failed capacitor can burn out a control board. A gate motor is a 120-volt or low-voltage electrical device wired into a control board, and it’s not a place for a homeowner to learn electrical work. The motor can also drop the gate suddenly if the arm is under tension when it fails. That’s a two-person job with the right tools, and it’s exactly what we do every day. If your Linear motor is failing, call us at (866) 623-9848 and we’ll tell you straight whether it needs replacing or repairing.
FAQs
Eight to twelve years is typical for a well-maintained Linear residential operator in Summerlin, and heat is the biggest variable. A motor that runs in full afternoon sun and never gets a seasonal check often fails closer to six or seven years.
Yes, sometimes. Capacitors, limit switches, and control boards are common repair items and often cost far less than a full replacement. We check those first before recommending a new motor.
Most Linear gate motor replacements take two to four hours on site, start to finish, including calibration and testing. Most jobs are done in a single visit.
We source OEM Linear motors and control boards where they’re still in production, and quality aftermarket equivalents for discontinued series. We tell you which one we’re quoting and why, upfront, before any work starts.
If your Linear motor is on its last legs, call Ironworks Gate Co. Summerlin at (866) 623-9848 for a free estimate. We also service LiftMaster, Mighty Mule, and Ghost Controls operators, and we’ll be there when we say we will.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin and nearby areas.