Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Keypad & Intercom Repair: The Summerlin Owner’s Guide
Replacing a failed Ghost Controls keypad or intercom in Summerlin typically runs $185 to $340 installed, and most of these swaps are done on the first visit. We service the full Ghost Controls line, so you’re not hunting for a brand-specific tech. Usually the problem announces itself at the pedestal: the gate stops taking your code, the keypad wakes up only when it wants to, or the intercom crackles whether you’re pressing the button or not.

Key Takeaways
- Installed keypad replacement in Summerlin: $185-$340, quoted before we touch a screw.
- Most failures here are connection or housing problems, not dead electronics.
- Every job we do is covered by our 90-Day Done Right Promise (the Keystone Standard) in writing.
Which Ghost Controls Models This Applies To
Ghost Controls builds its residential openers around a handful of series, and the keypad and intercom wiring is where model identity matters most. Their single-gate and dual-gate operator lines share the same accessory terminals, but the keypad housings, mounting plates, and intercom pigtails vary by series. The reliable way to match the right part is to read the model plate on the operator housing, not the keypad itself, then confirm the terminal layout on the control board.
The OEM-versus-aftermarket decision is real here. Ghost Controls’ own keypads carry their exact connector and code behavior. A quality aftermarket keypad can work fine, but it has to match the terminal voltage and input type the board expects, or it won’t take a code. We fit either, and we tell you which one we’re putting in before the price is agreed. This is where a generalist gets burned, because the wrong keypad looks identical and fails quietly.
Summerlin’s keypads sit in serious sun and heat, which is exactly why housing and gasket condition matter as much as the electronics inside. We’re an independent service provider, not affiliated with Ghost Controls, so we have no reason to push one part over another.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Ghost Controls Keypad & Intercom Repair Is Failing
- The keypad takes an old code but rejects a new one. That’s a board or firmware mismatch, not a dead keypad. Before you replace anything, it’s worth confirming the keypad is meant for that operator series.
- Codes work one day and drop the next. Usually a corroded terminal or a gasket that let Summerlin irrigation runoff and sprinkler overspray in. The fix is often a clean and reseal rather than a new unit.
- The intercom crackles or cuts out at one end. Typically a loose pigtail or water in the housing. Loose connections at the pedestal are the single most common fault we find.
- The keypad backlight dies and the buttons feel dead. Heat and UV break down the plastic and the contacts over time, and once the seal is gone the failures come faster.
- The gate opens from the wall switch but not the keypad. That isolates the fault to the keypad feed or the accessory wiring, which is why a proper terminal test saves you from buying the wrong part.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
| Item | Installed Range (Summerlin) |
|---|---|
| Keypad replacement (standard) | $185 – $265 |
| Keypad replacement (intercom-capable) | $240 – $340 |
| Intercom unit replacement | $220 – $340 |
| Re-terminate and reseal existing unit | $120 – $175 |
The range comes down to which series you have, whether we’re matching OEM or a quality equivalent, and whether the existing wiring can be reused or has to be re-run. Parts and labor are itemized, and the price is quoted and agreed before any work starts, so there’s no surprise on the bill. Our technicians have up to 13 years of experience, and the work carries a written 90-Day Done Right Promise.
DIY or Call Us?
You can safely check the obvious things: confirm the operator has power, look for water inside the keypad housing, and try a fresh code. What you shouldn’t do is work inside the control board or the intercom wiring while power is live. Low-voltage still bites, and a mis-wired keypad can take out the board with it, turning a $200 job into a bigger one. If the fault isn’t visible at the pedestal, it’s time to stop. Call (866) 623-9848 and we’ll come look, with a real person answering any hour.
FAQs
How long does a Ghost Controls keypad or intercom last in Summerlin? Expect roughly 6 to 10 years, less if the housing faces direct afternoon sun. UV and heat break the seals, so resealing early buys you years.
Can the keypad be repaired instead of replaced? Often yes, if the fault is a corroded terminal or water intrusion. We test before recommending a swap, and we tell you plainly when a reseal will do the job.
How long does the swap take? Most keypad and intercom replacements are done in under an hour. Wiring re-runs take longer, and we tell you the time before we start.
How do you source the part? We match it to your operator’s model plate and fit OEM or a quality equivalent, whichever you approve. The price is settled before we turn a bolt.
Call (866) 623-9848 for a free estimate. Standing offers include $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a 5% senior and veteran discount. We also service LiftMaster, Mighty Mule, and DoorKing keypads and access hardware.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin and nearby areas.