Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Gate Motor & Opener in Summerlin: What to Know First
We provide independent DoorKing gate motor and opener service throughout Summerlin, from 6050 swing operators to 1150 slide and 1601 barrier units. Most repair calls are handled on a single visit, and emergency no-open calls often get same-day attention. Pricing is quoted upfront and agreed before any work starts, so the number you approve is the number on the bill. This page is written for DoorKing owners in Summerlin who want their gate working correctly and want to know what it actually takes. Call (866) 623-9848 and a live person will pick up.

How DoorKing Products Fail – and How We Fix Them
DoorKing hardware is well-built. The failures we see in Summerlin are specific to how these units are built and how they age in this climate.
- Seized swing-arm bushings on 6050 series operators. The 6050 swing operator’s articulated arm gets stiff when the linkage dries out. Homeowners notice the gate slowing at mid-travel or stalling on the open cycle. Left alone, the motor fights the binding and the control board overheats. We free the linkage, replace worn bushings, and re-lubricate to factory specs.
- Obstruction-sensing faults from sun-baked photo beams. Summerlin’s midday sun breaks down the lens and reflector on inline photo beams faster than most places. The operator reads a phantom obstruction and stops or reverses at the same point every cycle. Genuine DoorKing replacement beams restore clean sensing; off-brand beams often fail this test.
- Board-level motor-control failures on 1150 slide operators. The 1150’s control board uses relay and capacitor circuits that corrode over years of summer heat. You’ll see the gate start, stall one or two feet in, then need a manual reset. We test the board and motor separately before recommending either, so you don’t replace a good motor to fix a failing board.
- Limit-switch drift on swing and slide units. Limit switches loosen from constant thermal expansion and the gate starts stopping short or over-traveling into its stop. We reset the limits to the actual physical travel of the gate, not to the old mark on the rail.
- Battery backup silently dying on 1601 barrier gates. The backup battery on a 1601 is supposed to carry the gate through a power cut. It’s often the last thing anyone checks until a power blip strands the gate. We load-test the battery and replace it with the DoorKing-spec unit rather than a generic battery that won’t hold voltage.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our DoorKing Gate Motor & Opener Process
- 1
The call. A live person answers 24 hours a day, 7 days a week. We ask about the model, the symptom and when it started so the tech arrives with the right parts.
- 2
Diagnostics on site. We test the motor, control board, limits, safety devices and power supply independently. The point is to find what actually failed, not to sell the largest fix.
- 3
The parts decision. We explain the trade-off between genuine DoorKing parts and quality aftermarket where it’s fair, note what each choice does to future service, and you decide before we order.
- 4
The repair. Background-checked, uniformed technicians do the work to factory torque and adjustment specs. Most DoorKing jobs are completed on one visit.
- 5
The test. We cycle the gate through full open and close, test the safety reverse and beam, confirm the backup battery and hand you the gate working correctly.
- 6
The guarantee. Every job is covered by our 90-Day Done Right Promise: if it isn’t right, we come back and make it right, no arguing, no paperwork.
See the difference
Before
After
Before
After
Before
AfterWhat DoorKing Gate Motor & Opener Costs in Summerlin
We quote a firm price before any work starts, so there’s no surprise on the bill. Typical Summerlin ranges:
| Job | Typical range |
|---|---|
| DoorKing diagnostic and limit/bushing adjustment | $150 – $280 |
| DoorKing control board replacement | $320 – $620 |
| DoorKing motor replacement (swing or slide) | $650 – $1,600 |
| Full DoorKing slide or swing motor install (new operator) | $1,800 – $3,400 |
| Backup battery replacement | $140 – $240 |
What moves the price: whether it’s a board, motor or linkage fix; genuine DoorKing parts versus quality aftermarket; gate weight and rail condition on slide units; and whether wiring or safety edges need attention. Estimates are free, and every quote is settled before a bolt is turned. Call (866) 623-9848 for an exact DoorKing number.
Why Summerlin Homeowners Call Ironworks Gate Co. Summerlin for DoorKing Work
Ironworks Gate Co. Summerlin is the dedicated gate specialist locals call when they want it done right and never want to think about it again. Proudly serving the area for over 42 years, founded in 1984, the company plans to be here another forty. We’re trained and equipped on nine gate-automation brands – including LiftMaster, Mighty Mule and Ghost Controls alongside DoorKing – so the correct fix is made on the first visit whatever is on the driveway. A live person answers the phone every hour of every day, our technicians are background-checked and uniformed, and every job is backed by the written 90-Day Done Right Promise. We’re an independent DoorKing service provider, not affiliated with or authorized by DoorKing.

FAQs
Can you repair a DoorKing operator rather than replace it? Yes, and repair is where we start. Most DoorKing failures in Summerlin are a board, a limit switch, a bushing or a battery, not a failed motor. We test each part independently and only recommend a full replacement when the motor itself has failed.
Do you use genuine DoorKing parts? We use genuine DoorKing parts when they’re the correct call and always explain when a quality aftermarket part is a fair alternative. For control boards, photo beams and backup batteries we default to genuine DoorKing because off-brand versions fail sooner in Summerlin heat.
How fast can you get to a DoorKing gate that won’t open? For an emergency no-open call, same-day attention is often possible. A live person answers the phone 24 hours a day, 7 days a week. Call (866) 623-9848 and we’ll tell you exactly when we can be there.
My DoorKing backup battery isn’t holding through a power cut – what’s going on? The battery has aged out or is being charged by a failing circuit. We load-test the battery and the charger together, because a new battery on a bad charger dies the same way. The fix restores reliable backup so a power blip doesn’t strand the gate.
Does Ironworks service other gate opener brands too? Yes. We service nine brands, including LiftMaster, Mighty Mule, Ghost Controls, FAAC, BFT, Linear, Viking, Elite and DoorKing. If you’re unsure what’s on your gate, we’ll identify it on the first visit.
Call (866) 623-9848 for a free estimate on your DoorKing gate motor or opener in Summerlin. A live person will answer, we’ll quote upfront and agree the price before any work starts, and the job is backed by our 90-Day Done Right Promise.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin and nearby areas.