Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterAutomatic Gate Repair in Summerlin, NV
Most automatic gate failures in Summerlin trace back to one of three things: a tired motor, a misaligned arm, or a safety sensor knocked out by summer heat. We repair all three on the first visit, and we back the fix with a written 90-Day Done Right Promise. If your gate has stopped opening, jammed halfway, or started grinding on the track, call (866) 623-9848 and a live person will pick up.
We handle the automation itself – the motor, the control board, the loop sensors, the keypad and remote receivers – alongside the hardware it drives. For the full scope of gate and hinge work beyond automation, see our Gate Repair in Summerlin page. Plainly put, if it moves on a track or swings on an arm and it is supposed to open by remote, we repair it.
Summerlin homes from The Ridges out to Red Rock Country Club sit on driveways where the gate runs every day, sometimes several times an hour. Those cycles add up. A FAAC or LiftMaster operator that was fine two years ago starts to lag when the desert heat wears down the gearbox grease and the battery in the control panel weakens. That is the moment to have it looked at, not after the gate stalls open at 10 p.m.
When You Need Automatic Gate Repair
These are the calls we take most often from Summerlin homeowners. If any of them sound familiar, the gate is telling you something.
- The gate opens a little, then stops. A partial cycle usually points to a failing limit switch or a weak battery backup in the operator. This is common on LiftMaster and BFT units here after a few years of daily summer cycling.
- It reverses for no reason. Safety loops and photo-eyes are the usual culprits. In Summerlin, sun-baked pavement can shift a loop enough to confuse the sensor, and the gate reads a phantom obstacle.
- The remote works only up close. A dying receiver board or a worn antenna is the likely cause. We test the whole signal chain rather than just swapping the remote.
- It grinds, squeals, or drags. Worn rollers, a dry track, or a bent arm. Left alone, the motor works harder until it burns out – so we fix the mechanical cause before the operator fails.
- The gate is stuck open or stuck closed. That is often a control board fault or a tripped manual release. We diagnose it on-site and tell you whether it is a board, a motor, or a simple re-engagement.
- You have to push it by hand to get it moving. A gate that needs a nudge has a motor losing torque or a hinge binding. On a Mighty Mule swing operator, this can be as simple as a capacitor – but it needs to be tested, not guessed at.
Automatic gates are heavy, spring-loaded, and wired to line voltage. The springs, cables, and motor capacitors that drive them can injure a person who is not trained to work around stored energy. We ask that you leave the repair to a trained technician – that is what we are here for, and it is the reason we carry the right parts for the job.
Our Automatic Gate Repair Process
Most automatic gate repairs in Summerlin are finished in a single visit. Here is how that visit goes, start to finish.
- We answer the phone – any hour. A live person picks up 24 hours a day, 7 days a week. No voicemail tree, no callback queue. You tell us what the gate is doing, and we book the visit.
- We come out and diagnose the whole system. That means testing the motor, the control board, the safety sensors, the arm or track, the hinges, and the wiring – not just the part that looks broken. This is how we find the actual cause and make the correct fix the first time.
- We give you an upfront price before any work begins. You hear the number, you approve it, and only then do we put a wrench to the gate. No surprises on the bill.
- We repair with the right parts for your operator. We are trained and equipped on nine gate-automation brands, including FAAC, LiftMaster, BFT, Mighty Mule, Linear, Viking, Ghost Controls, DoorKing, and Elite. Whatever is on your driveway, we carry the correct fix.
- We test every cycle and every safety feature. Open, close, reverse, sensor trip, manual release. We run the gate through its full range before we call the job done, so you are not the one who discovers a problem later.
- We back it in writing. Every completed repair is covered by our 90-Day Done Right Promise. If it is not right, we come back and make it right – no paperwork, no arguing.
Automatic Gate Repair Pricing in Summerlin
Automatic gate repair in Summerlin typically runs $180 to $650, depending on whether the problem is mechanical, electrical, or both. A safety-sensor realignment sits at the low end; a control board replacement or a motor swap lands at the high end. We give you the exact number on-site before any work starts, and the estimate is always free.
| Repair Type | Typical Range |
|---|---|
| Remote / receiver reprogramming or replacement | $95 – $180 |
| Safety sensor or loop realignment | $130 – $260 |
| Hinge, roller, or arm repair | $150 – $340 |
| Battery backup or capacitor replacement | $140 – $280 |
| Control board replacement | $280 – $520 |
| Motor / operator replacement (unit only) | $450 – $1,200+ |
A few things move the price. The brand of operator matters – some control boards cost more than others. Whether the gate is a sliding gate or a swing gate changes the labor. And if the mechanical hardware has been failing for a while, the motor may have taken extra wear that adds to the job.
We also carry standing offers that help on the bill: $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a permanent 5% senior and veteran discount. Our technicians have up to 13 years of experience, and they will walk you through what they find before they touch a thing. To check whether your repair qualifies for the discount, call us for a free quote.
FAQs – Automatic Gate Repair
How much does automatic gate repair cost in Summerlin?
Automatic gate repair in Summerlin usually costs between $180 and $650, with most common fixes – sensors, remotes, hinges, capacitors – landing under $350. The exact figure depends on your operator brand and whether the problem is mechanical, electrical, or both. Call (866) 623-9848 for an exact quote – estimates are free.
Can you repair my gate the same day?
In most cases, yes. Most automatic gate repairs are completed in a single visit, and a live person answers the phone around the clock so you can book as soon as you notice the problem. Call (866) 623-9848 and we will tell you the soonest we can be there.
Do you work on my brand of gate opener?
We service nine major gate-automation brands, including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. If your operator is one of these, we carry the correct fix and can usually sort it on the first visit. Not sure of your brand? Call (866) 623-9848 and we will identify it over the phone.
Why does my gate open partway and then stop?
A gate that stops partway usually has a failing limit switch or a weakening battery backup in the operator. It can also be a binding hinge that the motor cannot push past. Either way, it is worth having a technician test it before the motor is damaged further. Call (866) 623-9848 for a free estimate.
Related Pages
- Ironworks Gate Co. – Home
- Gate Repair – our parent service and the full scope of gate work
- Gate Repair in Summerlin
Book Your Automatic Gate Repair
A gate that will not open is a daily headache, and the sooner it is fixed, the sooner you stop thinking about it. We serve Summerlin homeowners with upfront pricing, a written guarantee, and a live person on the phone every hour of every day. Call (866) 623-9848 for a free estimate, and let us get your gate working the way it should.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin.