Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateViking Gate Installation in Summerlin: What to Know First
Viking gate installation in Summerlin typically runs $2,400 to $6,800 for a full driveway gate and operator setup, and most jobs are measured, ordered and scheduled within one to two weeks of the estimate. We’re an independent Viking service provider, so we quote the gate, the operator, the power run and the safety edges as one written price and settle it with you before any work starts. Call (866) 623-9848 and a live person picks up.

This page is for the Summerlin homeowner with a Viking operator already on the driveway, or one who’s been quoted an install and wants a straight second read on it. Viking equipment turns up across The Ridges, Red Rock Country Club, Tournament Hills and the older custom lots along Desert Foothills Drive. If you own one, what follows is written for your system, not a general gate page.
How Viking Products Fail – and How We Fix Them
Viking operators have habits. Knowing them saves you a return visit, because a Viking that misbehaves is almost never the whole operator failing. It’s one component, and it tends to be the same component the next time too.
- Armature and brush wear on the K-series swing and slide operators. Viking K-2 and K-4 units in heavy daily use start showing slow starts and a labored hum before they stop entirely. That’s worn brushes and a scored armature, not a dead board. We pull the motor, check brush length against tolerance, and rebuild or replace the armature rather than sell you an operator you don’t need.
- Receiver and remote binding dropouts. Viking Q-4 and Q-7 receivers drift out of sync with the remote after a battery change, and owners often assume the board is gone. Nine times in ten we re-bind the remote and test range from the street instead of the driveway apron, which is where Summerlin’s low-e window coatings on the house actually interfere.
- Limit switch creep on Viking slide operators. The gate stops short or over-travels by a few inches. On Viking slides the limit cams loosen with heat cycling faster than on LiftMaster or DoorKing units, and the fix is a re-set and a thread-locking compound – not a new control board.
- Battery backup failure in the 24V Viking units. Viking’s battery-backup versions live in a metal enclosure that cooks in a Summerlin summer. We test the battery under load, not just at the terminals. A battery that reads 12V at rest can still fail the moment the gate needs it, and that’s the one time it matters.
- Entrapment sensor and photo-eye faults after a Summerlin dust event. Spring wind off the Red Rock side lifts fine caliche dust, and it settles on the Viking photo-eye lenses. The gate reverses mid-travel and the owner thinks the operator has failed. We clean, realign and re-test the safety circuit – and we check the lenses were mounted where dust can actually reach them, which is often the real fix.
If your Viking model isn’t on that list, don’t worry. We’re trained and equipped on nine gate-automation brands, Viking included, so we diagnose the unit in front of us rather than the one we saw last week.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Viking Gate Installation Process
- 1
Call and phone diagnosis. A live person answers, 24 hours a day, 7 days a week. We ask model, age and symptom and book a visit that fits your schedule, not the other way around.
- 2
On-site measurement and full inspection. We check the gate leaf, the hinge posts, the operator mounting, the power run and the safety edges. On a new install that means confirming the gate swings or slides true before the Viking operator goes anywhere near it.
- 3
Written, upfront price. We quote the install or the repair, and we tell you whether the fix is OEM Viking parts or a quality aftermarket equivalent. Some Viking components have aftermarket replacements that hold up; others don’t, and we’ll tell you which is which for your model.
- 4
The work, done right. Our technicians have up to 13 years of experience, are background-checked and uniformed, and most jobs are completed in a single visit.
- 5
Test and safety verification. We run the gate through a full open-close cycle with the safety edges and photo-eyes live, and confirm the reversal force is set to code for the gate weight.
- 6
Cleanup and the 90-Day Done Right Promise. We leave the site clean, hand you the written guarantee, and stand behind the job. If something isn’t right, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Viking Gate Installation Costs in Summerlin
Here are the ranges we see on Viking jobs in Summerlin. Every price is written and agreed before work starts, so the bill matches the quote.
| Job | Typical range |
|---|---|
| Viking operator replacement on an existing gate | $1,200 – $2,600 |
| New Viking driveway gate install (single swing or slide) | $2,400 – $6,800 |
| Pedestrian or security gate with Viking operator | $1,800 – $3,900 |
| Double gate with two Viking operators | $4,500 – $9,200 |
| Viking control board or receiver repair | $220 – $480 |
| Safety edge and photo-eye installation | $180 – $420 |
What moves the price: gate weight and material, the length of the power run from the panel, whether the gate needs new hinges or welding before automation, and whether you choose OEM Viking parts or aftermarket. We also carry standing offers – $50 off any repair over $250, a free second opinion on any written estimate, an $89 seasonal tune-up, and a permanent 5% senior and veteran discount. Estimates are free. Call (866) 623-9848.

Why Summerlin Homeowners Call Ironworks Gate Co. Summerlin for Viking Work
We’re a gate specialist, not a general handyman who happens to own a welder. That matters on Viking work, because Viking operators ask for a real understanding of the motor, the board and the gate itself. Our technicians have up to 13 years of experience, and every job is backed by the 90-Day Done Right Promise – written, no arguing, no paperwork. A live person answers the phone 24 hours a day, 7 days a week. And because we’re trained on nine brands including LiftMaster, Mighty Mule, Ghost Controls and DoorKing, we’re not going to talk you into a Viking part when a compatible one is the right call. We treat your home the way we’d treat our own mother’s – background-checked, uniformed, careful. Call (866) 623-9848.
FAQs
No, as long as the work is done to Viking’s spec. As an independent Viking service provider we follow Viking’s installation requirements and use OEM parts where the warranty calls for them, so the manufacturer warranty stays intact. We’ll tell you upfront if a job needs OEM to protect the warranty. Call (866) 623-9848 for a free quote.
Yes. We’re trained and equipped on Viking and the other major brands, so common Viking parts are handled without the long waits you get from a generalist. Some model-specific boards take special order, and we’ll tell you the lead time at the estimate. Call (866) 623-9848 and we’ll check your model.
Repair makes sense when the problem is a single component – a brushed-out motor, a dead receiver, a worn armature. Replace when the board is obsolete or the motor is failing in multiple ways at once. Our technicians have up to 13 years of experience and will give you the honest call, not the expensive one. Call (866) 623-9848 for a free estimate.
Often yes for repairs. A live person answers 24 hours a day, 7 days a week, so call and we’ll tell you the soonest visit for your gate. Full new Viking installs are measured, ordered and scheduled rather than same-day – we’ll give you a written price and a date. Call (866) 623-9848.
Yes. A complete Viking install includes the power run from your panel, the safety edges and the photo-eyes, all tested and verified before we hand you the guarantee. That’s the full scope – no separate electrician to chase. Call (866) 623-9848 for a free quote.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin and nearby areas.