Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterGate Realignment in Summerlin, NV
Gate realignment in Summerlin typically costs $185 to $420 for a driveway gate and is usually finished in a single visit. Realignment is the work of bringing a sagging, dragging, or crooked gate back to true – adjusting hinges, resetting posts, and correcting the swing so the gate latches cleanly and the opener stops straining. Ironworks Gate Co. Summerlin handles that work as a dedicated gate specialist, not a generalist outfit, and every job is backed in writing. If your gate has dropped enough that you’re lifting it by hand or the motor sounds like it’s fighting back, call us at (866) 623-9848. A live person answers, day or night.
Realignment sits inside our broader Gate Repair work, and it’s the repair we get called for most often in the older stretches of Summerlin. Metal doesn’t fail all at once. It drifts, half an inch a season, until one morning the gate clips the driveway and the whole thing feels wrong.
When You Need Gate Realignment
You don’t need to diagnose anything. If the gate doesn’t close the way it used to, that’s reason enough to have it looked at. Here’s what we see most often around Summerlin:
- The gate drags on the ground or clips the driveway. A wooden or steel gate that’s dropped a half inch at the latch side is usually a hinge or post problem, not a gate problem. Left alone, it wears the finish off the bottom rail and stresses the opener.
- It swings crooked or won’t latch without a shove. A gate that needs a shoulder to close is out of square. On the sun-baked west-facing drives in The Ridges, we see this after a summer of heat cycling that moves the posts just enough to change the geometry.
- The opener strains, reverses, or trips its sensor. LiftMaster and FAAC operators are built to move a true gate. When the gate is out of alignment, the motor compensates until it can’t – then it stops mid-travel or reverses on close. That’s a realignment signal, not a motor failure.
- The gate leans after wind or a vehicle bump. Summerlin’s spring wind events and the occasional bumped gate leave posts slightly out of plumb. You’ll see the gap at the latch change from one side of the opening to the other.
- Hinges are worn, loose, or bent. Worn hinges pull a gate out of alignment every time it opens. We check hinge welds and pivot pins as part of any realignment, because a true gate on tired hinges is going to drift again.
- You’re selling or having the gate re-finished. A crooked gate makes a driveway look neglected. If you’re having the gate painted or re-stained, realign it first so the finish cures on a gate that sits true.
If Mighty Mule or BFT automation is part of the picture, realignment matters even more. Those openers have travel limits set to a specific gate position. When the gate shifts, the limits are wrong, and the operator stops doing what it was told.
Our Gate Realignment Process
We start with the gate, not the motor. Here’s how a realignment visit runs:
- Inspect the full swing path. We check post plumb, hinge condition, weld integrity, and the gap at the latch. We watch the gate travel by hand before powering the opener. That tells us whether the drift is in the posts, the hinges, or the gate frame itself.
- Set the posts and hinges back to true. Where a post has moved, we reset and re-anchor it. Where hinges are worn or bent, we replace them. We re-weld or tighten the frame if a corner has opened. This is the part most one-visit fixes skip, and it’s the reason a gate drifts again two months later.
- Re-square the gate and confirm the latch. The gate needs to close square, contact the latch cleanly, and sit level across the opening. We check that by hand with the operator off.
- Recalibrate the opener. Once the gate is true, we reset the travel limits and force settings on the operator. This is where certified training on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule pays off – the correct fix happens on the first visit, whatever is on your driveway.
- Safety check and walkthrough. We test the reversing sensor, check the photo-eye alignment, and walk you through what we adjusted. No paperwork, no surprises on the bill.
A word on safety: gate posts under tension and openers wired into the home’s power are not a DIY project. A gate that drops while you’re under it, or a motor that fires unexpectedly, can cause serious injury. Leave the realignment to a trained technician, and let us handle the power and the load.
Gate Realignment Pricing in Summerlin
Most realignment work in Summerlin lands between $185 and $420, with the exact figure depending on what’s out of true. Here’s how the ranges break down:
| Job | Typical Range |
|---|---|
| Hinge adjustment and latch re-square (gate true, hinges okay) | $185 – $260 |
| Hinge replacement, one or both sides | $240 – $360 |
| Post reset and re-anchor (single post) | $280 – $420 |
| Opener travel-limit recalibration after realignment | $95 – $165 |
| Weld repair on a frame or hinge | Quoted on site |
What drives the number: how far the gate has drifted, how much of the post has to be reset, whether the opener needs recalibration, and whether the gate frame has cracked a weld. A gate that’s been dragging for two years costs more to bring back than one that started sticking last month. That’s the honest answer.
We settle the price upfront, before a single bolt is turned. Our standing offers apply: $50 off any repair over $250, a free second opinion on any written estimate, our $89 seasonal tune-up, and a permanent 5% senior and veteran discount. Estimates are free, and they’re not a sales pitch. Call (866) 623-9848 for yours.
FAQs – Gate Realignment
How much does gate realignment cost in Summerlin?
Gate realignment in Summerlin usually runs $185 to $420, with most homes landing near $260. The price depends on whether we’re adjusting hinges, replacing them, resetting a post, or recalibrating the opener after the gate is true. Estimates are free – call (866) 623-9848 for an exact quote on your gate.
Can you realign my gate the same day?
In most cases yes. We keep realignment stock – hinges, pivot hardware, weld consumables – on hand so the job finishes in one visit. A car bump or a post that’s settled after a monsoon can turn a simple adjustment into a two-part fix, and we’ll tell you that upfront before we start. Call (866) 623-9848 and we’ll give you a realistic window.
Will realignment fix my gate opener, or will I need a new motor?
Realignment fixes the gate, and a true gate often fixes the opener’s problems. When a LiftMaster or FAAC operator reverses or stops mid-travel, it’s usually because the gate is out of alignment and the safety limits are tripping. Once we realign the gate and recalibrate the travel limits, the motor often runs normally again. If the motor has genuinely failed, we service nine brands and can tell you plainly what’s needed. Call (866) 623-9848 and we’ll diagnose it on site.
Why does my Summerlin gate keep drifting out of alignment?
Most repeat drift comes from a post that wasn’t set or re-anchored properly the first time, or from hinges that are worn and pulling the gate out of square on every cycle. Summerlin’s heat cycling and seasonal wind events move posts over time, and a gate with a tired hinge will drift faster. A realignment that resets the post and replaces the hinges stays true. One that just tweaks the latch won’t. Call (866) 623-9848 to have us check yours.
If your gate has dropped, gone crooked, or started fighting its opener, get it looked at before the motor or the frame pays the price. Ironworks Gate Co. Summerlin does realignment right – backed in writing by our 90-Day Done Right Promise, with upfront pricing and no surprises on the bill. Our technicians have up to 13 years of experience, and a live person answers every call, 24 hours a day. Call (866) 623-9848 for a free estimate, and we’ll be there when we say.
Written by the team at Ironworks Gate Co. Summerlin, serving Summerlin.